PHG-2081X Industrial ph and ORP Meter

PHG-2081X Industrial ph/ORP Meter


Attention
Please read the following instructions for safe operation before use.

1.Please observe whether the appearance of the instrument is damaged by the squeeze of the transportation before use.
2.Read the operating manual before use to avoid incorrect wiring .
3.After all wiring is completed, it must be checked carefully before sending power and confirming that the connected equipment is correct.
4.Please avoid the high temperature, high humidity and corrosive environment, and avoid direct sunlight.
5.Avoid using power supplies that cause surge interference. If there is surge interference, please separate the power supply of the instrument from other power sources.

Introduction
Instrument for industrial pH/mV ORP and temperature measurement, such as Waste water, drinking water environmental monitoring, fermentation, food production process etc.
Instrument for panel mounted,wall mounted,pipe mounted.
Instrument provide 2 ways of 4-20mA ,max load 500Ω.
Instrument provide 3 ways of relays ,max 5A/250VAC or 5A/30VDC.
Instruments provide RS485 Modbus RTU communication.

Product&Accessory
Instrument includes: one instruments,one user manual,four sets of support(thread,fixed bar,fixed block)


Specification
Function
pH
ORP
Range
-2.00 ~ +16.00 pH
-2000mV ~ +2000mV
Resolution
0.01pH
1mV
Accuracy
±0.01pH
±1mV
Temp. Comp. Element
Pt 1000/NTC10K
Temp. Measure range
-10.0 ~  +130.0℃
Temp. Comp. Range
-10.0 ~  +130.0℃
Temp. Res0lution
0.1℃
Temp. Accuracy
±0.2℃
Working Temp.
0 ~ +70℃
Storage Temp.
-20 ~ +70℃
Input Impedence
>1012Ω  
Display
Ultra-large dot matrix LCD with backlight
pH/ORP Output 1
Isolated 4~20mA,max load 500Ω
Temp Output 2
Isolated 4~20mA,max load 500Ω
Current Output Accuracy
±0.05 mA
RS485
Standard Mod bus RTU
Communication Rate
9600/19200/38400
Relay Contact
5A/250VAC,5A/30VDC
Clean set
ON: 1~1000 seconds, OFF: 0.1~1000.0 hours
One Multifunctional Relay
Clean/Period alarm/ Fault alarm
Relay Delay Action
0-120 seconds
Data record
500,000 times
Language
English/繁体中文/简体中文
Protection
IP65
Power
90~260VAC, consumption <7watt
Installation
Panel/Wall/Pipe mounted


 Contact Email:michael@shboqu.com, Mob:86-15000087545



评论

发表评论

此博客中的热门博文

SJG-2083C INDUCTIVE ACID ALKALI CONCENTRATION METER

图片
SJG-2083C   INDUCTIVE ACID ALKALI CONCENTRATION METER SJG-2083C is inductive type acid alkali concentration meter,it's with inductive conductivity sensor,the measuring principle of the infinite sensor is a pair of wirewound alloy toroidal coils. The probe of the sensor is completely isolated from the measured process solution (non-contact). Two coils, one for transmitter and the other for receiver. When the transmitter coil is energized, the electrolyte solution conducts electricity and generates an induced current, which is directly proportional to the conductivity of the solution. The receiver coil detects the magnitude of this current and thus obtains the conductivity value of the solution. Conductivity probe alloy toroidal coil is customized in the toroidal molding with corrosion resistance. Because the probe of the sensor is completely isolated (non-contact) from the process under test (liquid), frequent maintenance and maintenance are not required.
阅读全文

CODS-3000-1 DIGITAL RS485 COD SENSOR

图片
CODS-3000-1  DIGITAL RS485 COD SENSOR Measuring Principle     The BOQU Digital Online COD Sensor is based on the absorption of ultraviolet light by organic matter, and uses the 254 nm spectral absorption coefficient SAC254 to reflect the important measurement parameters of soluble organic matter content in water, and can be converted into COD value under certain conditions. This method allows for continuous monitoring without the need for any reagents. Application 1)Continuous monitoring of organic matter load in the sewage treatment process 2)0n-line real-time monitoring of  influent and outflow water of the wastewater treatment 3)Application:surface water, industrial discharge water, and fishery discharge water etc
阅读全文

AH-800 Online Water Hardness and Alkali Analyzer

图片
Online W ater H ardness /Alkali   A nalyzer Model:AH-800 Online Water hardness and Alkali analyzer monits water total hardness or carbonate hardness and   total alkali  fully automatically via titration. Description Th is   analyzer  can measure water total hardness or carbonate hardness  and total alkali fully automaticlly via titration. This instrument is suitable for recognising levels of hardness, quality control of water softening facilities and monitoring of water blending facilities. The instrument allows two different limit values to be defined and checks the water quality by determining the absorbtion of the sample during titration of the reagent. The configuration of the many applications is supported by a configuration assistant. Features ◇ Reliable, exact and fully automatic analysing ◇ Simple commissioning with configuration assistant ◇ Self calibrating and self monitoring ◇ High measuring accuracy ◇ Easy maintenance and cleaning. ◇ Minimal reagent
阅读全文